usb-storage 3-10:1.0: USB Mass Storage device detected usb 3-10: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 3-10: New USB device found, idVendor=2237, idProduct=4223, bcdDevice= 1.10 usb 3-10: new high-speed USB device number 2 using xhci_hcd Here are the lsusb and dmesg output in the second case: when the reader is visible from the computer: I suspect an hardware problem with my reader. Looking at dmesg I see some error message. However any attempt to access it close the connection from the computer side: the device is kind of "ejected". If I reboot the computer with the Reader plugged, I can see it with Thunar and Calibre detect the device. The reader is not mounted: it's not appearing in Thunar, Calibre can't see it, no mounting point corresponding appear in mount output. However in most of the case nothing happen. dmesg show a connection on a USB port with no error message. From the computer side now the lsusb command see perfectly the Reader, its number. When I plug the reader via the USB cable, the reader ask to be connected (or not) with the computer.I accept and then the reader show the message "you are connected blablabla". In fact both OS are up-to-date (Kobo OS on the reader and Arch on the computer). I suspect an hardware problem on the reader. My problem is to connect the reader to my computer. Well for reading book and so it's works as expected. I have to play with Calibre even more or face more problems so I can figure things out more.I have a Kobo EPub reader that works perfectly. And to have it happen when the device is connected, go to the "Sending books to devices" page of the calibre preferences and set the "Metadata management" option to automatic. For either the built-in KoboTouch driver or the KoboTouchExtended driver, go to the third tab and enable the appropriate options in the metadata updating section. That is in the driver and other calibre preferences. You can configure it to be for all devices, or individual devices. That way only one set of columns is needed. In your case, as there is one person using multiple devices, you can setup one profile with the device "* Any Device". But, the dialogs also have an option to choose a different profile. And the plugin automatically selects the profile for the connected device. That way they can fetch the reading status without clobbering the other persons status. And that is most likely used where different people are sharing the library. They are mainly there if to have each device updating to a different set of columns. The profiles in the configuration can be used for multiple devices. The dialog displayed has options to choose which direction and exactly what gets set. On the plugins menu, it is "Store/Restore current bookmark". Calibre, Kobo Libra 2 and Clara) are all sync relative to reading progress?Īnd pardon this newbie question, how to setup edits in the metadata to be automatic when connecting kobo devices to Calibre? Thank you I understand now how the date determines the updating process.Ĭorrect me if i am wrong, but in the Kobo Utilities plugin, i have to check the "Store current bookmarks on connect" for this to happen right?Īnd in your statement "Select the books you want to update and run the function", what exactly is "RUN THE FUNCTION?" Is there anything i need to click/set-up when i want to update reading progress in say, another kobo device so that all three (i.e. And that always overwrites the status on the device. But, sending it to another device is manual: Select the books you want to update and run the function. And it can check dates and status so it will only do it if the current reader has status later than what is in the library. The fetch of the status can be configured to be automatic.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |